DC Strip-Strip Connector + wire -RGB
In Stock
These connectors are used to join two DC RGB Led strip lights together at the cuttable parts when extending or repairing the strip light.
Also used in angle joinery.
Related products
-
These are electronic switching devices used to switch on-off power for heavy loads using a secondary low current switch such as timers, motion sensors and photocells.
- It has no moving parts which wear out enabling it to last long.
- Protects appliance from transients because they have zero voltage turn on-offs.
- Instant switching with no delays.
Application – Room heaters, water heaters, lights and signage.
-
These are four pin connectors used to connect an RGB strip light to a 24 key RGB remote controller.
-
These connectors are used to connect a cut RGB Led strip light to a 24 key controller using the four pins connector.
-
This product adopts a good sensitivity detector as it utilizes the infrared energy from humans as a control signal source to switch lights on and off. By the use of this PIR Sensor, considerable energy can be saved by switching off the lights when the space is not in use. Savings are huge in larger facilities.
- Detection range of 360 degrees.
- Has a timer for adjusting the lights on longevity.
- IP20 rating for indoor use only.
- Lux detection control
- Surface mounted.
Application – corridors, Lift Lobbies, washrooms, garage, basements and warehouses.
-
These connectors are used to connect a cut section of strip light to a power supply unit with a male jack pin.
-
These simple and easy to use power plugs with dimmer are used to connect an 8/10mm single colour Led strip light which is 220/240v AC.
- Comes with a pin connector and end cap.
- Dimmable.
- Easy to use and install.
- Can connect upto a maximum of 40 meters length.
